Hi Jim & Lyn,
G'day all,
Just been talking to Eelezy (G'day mate!) whose on his way north and he had what could have been a really serious issue on his tvan. One of the hinge pins for the rear hatch - the one that holds the tent - broke. Fortunately he discovered it before serious damage occurred.
SO .. I checked one of mine which are a LOT older than his and the one I checked is seriously worn. I've replaced it with a bolt temporarily until I hear from Track about replacements.
Mines an 05 but I think Eelezy is about a 2013 or thereabouts.
You can remove them with the hatch closed. I needed a little jack pressure under the bottom lip of the hatch just to get the alignment right for easyish removal. Don't remove both at the same time!
And yes this is the pin at the top of the hatch behind that piece of metal that no-one knows the reason for at the very top. The pin has an Allen key head.
Hope I didn't steal the best bits of you story Chris!
Cheers
Jim
This is in response to your post above. I noticed similar problem with the pin on the off side of my TVan. It is a 2014 model & was surprised to see how much the hole had flogged out. There is so much movement that the rounded part on the hatch is digging into the fiberglass on the body of the van. I was thinking of getting a mate to make me a stainless steel bush to take out the movement of the bolt. Guessed it would be cheaper than getting the 2 new pivot parts from Track. The bolt does not seem to be worn. Still to pull the bolt out and check it.
Cheers,
Phil
G'day all,
Just been talking to Eelezy (G'day mate!) whose on his way north and he had what could have been a really serious issue on his tvan. One of the hinge pins for the rear hatch - the one that holds the tent - broke. Fortunately he discovered it before serious damage occurred.
SO .. I checked one of mine which are a LOT older than his and the one I checked is seriously worn. I've replaced it with a bolt temporarily until I hear from Track about replacements.
Mines an 05 but I think Eelezy is about a 2013 or thereabouts.
You can remove them with the hatch closed. I needed a little jack pressure under the bottom lip of the hatch just to get the alignment right for easyish removal. Don't remove both at the same time!
And yes this is the pin at the top of the hatch behind that piece of metal that no-one knows the reason for at the very top. The pin has an Allen key head.
Hope I didn't steal the best bits of you story Chris!
Cheers
Jim
This is in response to your post above. I noticed similar problem with the pin on the off side of my TVan. It is a 2014 model & was surprised to see how much the hole had flogged out. There is so much movement that the rounded part on the hatch is digging into the fiberglass on the body of the van. I was thinking of getting a mate to make me a stainless steel bush to take out the movement of the bolt. Guessed it would be cheaper than getting the 2 new pivot parts from Track. The bolt does not seem to be worn. Still to pull the bolt out and check it.
Cheers,
Phil

??