Track Trailer Forum

The front being prepared

Making the front to hold remote control receiver , supply grilles and return air grille. It has to be easily removed to clean the filter.

From the front so far

Sides screwed on

More of the wall bracket.

There is a bracket on 3 sides of the unit at the top to hold it in place and then i have screwed in angle top and bottom on both sides to hold the walls around the air con.The floor carpet is cut and back in place.

I have sealed the holes in the floor with bitumen paint and then screwed mesh over them

More to come as i finish it

The air con fits nicely but i did have to take the high bits off the insulation

Slide in and sealed around the sides

the base all together

I have then sealed the bottom HDPE to the floor around the holes and screwed it all to the floor.
You will also see the strips i put on the side to guide the middle moving sheet

Underneath, dont look to much at my woodworking skills. It just fits between the floor framework

The holes are cut to match the a/c holes in 2 of the sheets and the other is offset so it matches the holes when slid out and seals them when in.I have measured and the only place for the unit to line up with the trailer frame is in the centre. I would have prefered too the side but it will not work.

More of the slide